Bluefish JL-6500 Aquarium Water Pump DC 24V Submersible Brushless Pump For Pond Fish Fountain Garden House Water Hydroponic

1.Anhydrous power : when the water pump is in the anhydrous state, the power supply is connected, and the water pump is raised to the highest speed. The water pump is enter a low speed rotating state, that is anhydrous protection state setted . This situation in the water environment after the operation, if the detection of water shortage, the water pump is also transferred from the load to the state of anhydrous protection, both low speed rotating state! 2.Water to electrify : when the water pump is in the water state, turn on the power supply, the pump will be in the maximum speed state, at this time, you need to use the acceleration and deceleration function button to adjust to the required flow and lift. 3.Power failure memory function : according to the set required for optimum flow and lift to step 2 after adjustment, such as 5 gear, press the start and stop button, the pump to stop running, such as lights have been extinguished, again press the start and stop button to start the pump, the pump into the memory state, if in the process of using electricity, etc. call the water pump to start running will run directly into the adjusting gear (gear 5) 4.Feeding function setting : While feeding, press the start and stop button, the pump immediately into the stop operation, the lights will be extinguished at this time, 15 minutes after the water pump to resume its normal working state.

1.Packaging products : submersible pump, intelligent controller, filter cover, adapter, adapter (2 Pieces), mat, O-ring. 2.The filter cover and adapter are installed in the inlet and outlet of water pump, the water pump is not placed under the water before does not rotate it please, usually put the pump into the water, and then connected to the power supply. When the initial operation, the water pump may not pumping, because the pump has air inside, firstly you can disconnect the power supply, and then repeatedly connected to the power several times, the pump can run properly.

When washing the water pump, clean the stolen goods in water. If the water pump doesn’t work properly, please check it as follows : 1.Check whether the circuit is disconnected or not,ensure that the pump is connected to the power supply.Notice: do not to switch on the power before operation. 2.Check whether pump’s outlet and water pipe is spoils or not. 3.Check intake to ensure inlet is not blocked by spoils. 4.Check the inner cavity of the water blade rotor and turn the water blade rotor to ensure that the rotor is not broken or stuck. 5.Regular monthly inspection will increase the service life of the pump.